Birdman1 goes UNISENS-E TELEMETRY to futaba

This is the product that we use :

https://www.sm-modellbau.de/UniSens-E-und-Zubehoer

it exist with different connections but all have the same function

this is a english manual : http://www.f5b.co.uk/wp-content/uploads/2016/01/Unisens-E-v1.11-english.pdf

this is my add on to that manual

for starters :our tools

Unisens-E

USB link Unisens

pc Programm : https://www.sm-modellbau.de/PC-Software

start the program 

 make connection with the usb link

 check the com port and make sure that you select the correct one 

 push the connection button 

 for FUTABA : select FUTABA 

FOR OTHERS CHECK THE LIST

Adjust the different options and CONFIRM your choice

check if everything got stored!

next step 

 tools: in my case T18SZ FUTABA

S7008R RECEIVER THAT IS ALREADY BIND TO TRANSMITTER IN THE CORRECT PROGRAM

Bec and batt supply  ( or one can use a standard receiver battery)

Prepare your transmitter to the correct plane / heli / multi program  

connect (on the back of your transmitter ) the Unisens-E  with the proper servo connection

go to menu "linkage menu" 

continue to menu "Sensor" 

 below the screen where you end up

 go to page 3/3

THIS IS WHAT YOU SEE ON PAGE 3/3 

 TAB the "REGISTER" button 

when everything is okay you get the following message 

Tab the "REGISTER " button again 

 And again

until you get the message below, now all sensors are registered !

 go back to the first tab 1/3

 if everything went okay then you have now the following screen

return to the standard menu and select "telemetry" 

 and check tab 1/2

 and tab 2/2

following step

connect the Unisens-E to the Sbus 2 position on the receiver 

  

 this is how my present setup looks

 

 the second servo connector with single wire can be used depending on your transmitter but is no must.

Once connected you should get this